• Amethyst Bracelet & Earrings • |
|
For Necklaces:
• Beadalon® 19 Strand wire, .018” diameter, bright colore
• Twenty-three assorted 8-10mm amethyst glass beads
• Two 2mm silver crimp tubes
silver toggle clasp
• Ten silver head pins
• Round nose pliers
• Beadalon Nipper tool
Earrings:
• Two 8mm amethyst glass beads
• Two 10-12mm amethyst glass beads
• Two silver head pins
• Two silver eye pins
• Two silver ear wires
• Beadstrom™ Round Nose pliers
• Beadalon Nipper tool |
|
|
|
Project Tip:
For a quick and easy version of this bracelet, simply omit the beaded charms. |
Necklaces:
1. Cut three 12" lengths of Beadalon® 19 Strand wire. Hold the strands together and string a crimp tube 1/2" from the end. String the wire through half of the clasp and back into the crimp tube to form a loop. Use crimping pliers to crimp the crimp tube.
2. On one strand, leave 1/2", then string a glass bead. Wrap the Beadalon® wire around the bead and place the end of the Beadalon® wire back through the same hole to hold it in place. String five beads 1" apart along the length of the strand.
3. Leave 3/4" and 1" on the other strands, then repeat the technique to string four beads 1" apart along the length of the strand.
4. Hold the strands together and string a crimp tube and half of the clasp. Place the strand ends back into the crimp tube to form a loop. Adjust the strands so the bracelet is 7 1/4" long (or the desired length). Use crimping pliers to crimp the crimp tube.
5. String a glass bead onto a head pin. Use round nose pliers to make a loop above the bead. Trim off any excess wire. Make ten beaded pins. Open the loops and attach one beaded pin between every two beads on the bracelet.
Earrings:
6. Choose two sets of larger matching glass beads and two sets of smaller matching glass beads. String the larger bead onto an eye loop. Use round nose pliers to make a loop above the bead. Trim off any excess wire, then attach the beaded pin to an ear wire. String the smaller glass bead onto a head pin and make a loop above the bead. Trim off any excess wire and attach the smaller bead to the loop below the larger bead. Repeat for the other earring.
|
|
|
|
