1. Open a lightweight jump ring just enough to string onto one of the rose top drilled pendant, and then attach to one of the rings of the filigree connector. Open a second jump ring, string a second pendant and attach to the other ring skipping the middle ring.
2. Use chain nose pliers to open 2 of the 4mm jump rings, string onto the middle ring of the filigree connector and attach to the top ring of a second filigree connector and then close gently.
3. Use crimp tool to attach one pinch bail to the Swarovski heart pendant. Create 2 more heart pendants repeating the last step. Be gentle doing this step so you do not squeeze pinch bails to the point of breaking crystals. Just close enough to secure pinch bail around the pendants.
4. Using round nose pliers make a simple loop on a 2 inch piece of silver wire, trim excess with flush cutter. String the following beads: 1 peridot + butterfly + 1 peridot. Make a second simple loop and then trim excess wire again.
5. Open one of the loops of piece made from step 4 and attach one piece made from step 3 and then close gently.
6. Open a 4mm jump ring and slide through of pieces made from step 3, and then attach to one of the rings of the filigree connector. Attach piece made from step 5 to the middle ring and then attach another heart to the third ring.
7. Open the ring on the leverback with the Beadalon chain nose pliers, and then attach the top ring of the connector that has the briolettes attached.
8. Repeat all steps to complete the matching earring. |
|
