1. Cut the Beadalon 7 in three equal lengths.
2. Hold the wires together and pass them through a Crimp Bead and a bead tip.
3. Adjust the wires so ¼" extend from the Crimp Bead, and then use Mighty Crimping Pliers to crimp it.
4. Use tape or a binder clip to attach the crimped wires to your work surface, and then braid them together.
5. Pass the braided wires through a bead tip and a Crimp Bead.
6. Crimp the Crimp Bead, and then use the Mighty Crimping Pliers to close the bead tip.
7. Detach the braided wires from your work surface, cut off the extra 1/4" before the braid, and then close the bead tip.
8. String the enameled copper pendant and the Toggle Ring loop onto a Jump Ring.
9. String a copper disk bead onto a head pin and make a wrapped loop to attach it to the Toggle Ring.
10. Attach the Jump Ring with dangles to the center of the necklace wire.
11. Use a Jump Ring to connect the Lobster Clasp to the bead tip loop on one end of the necklace.
12. Connect a Jump Ring to the bead tip loop on the other end of the necklace. |
|
