1. Using the largest portion of the Designer chain nose pliers and one of the fancy connectors, carefully bend the connector until it forms a half circle.
2. String onto a Ball/Star headpin one of the rings of the connector altered in step 1, then 1 sew-on erinite stone (flat side up), then one square alabaster cube, one sew-on erinite stone (flat side down this time), then carefully through the top ring of the fancy connector from step 1.
3. Form a loop using the Designer Chain nose pliers, approximately 1/8” above the top of the connector with the end wire of the headpin wire, then wrap the excess wire around the stem until flush with the connector.
4. Cut 1pc. of chain 7 links long. Open end link and attach to the item made in steps 2-3.
5. Using the Beadalon chain nose pliers carefully crush the center of every-other chain link to add interest to the chain.
6. Slide two bead bumpers onto the wire of the Lever Back earring and slide them all the way to the base, then string on one peridot pendant, then slide on another two bead bumpers and push into place to hold the peridot pendant forward on the Lever Back.
7. Open the ring on the Lever Back earring and attach to the end of the chain.
8. Repeat above steps to complete other earring. |
|
