1. Using the largest portion of the Designer chain nose pliers and one of the fancy connectors, carefully bend the connector until it forms a half circle.
2. String onto a Ball/Star headpin one of the rings of the connector altered in step 1, then one of the 8mm Tanzanite crystal beads, then carefully through the top ring of the fancy connector.
3. Form a loop using the Designer Chain nose pliers, approximately 1/8” above the top of the connector with the end wire of the headpin wire, then wrap the excess wire around the stem until flush with the connector.
4. Open one of the 4mm Jump Rings, attach it to the item made in step 3 then to the French wire and carefully close jump ring.
5. Repeat above steps to complete other earring. |
|
