Instructions:
1. Open a solid oval jump ring using the tips of round nose pliers, and then attach through folded strand of ivory shell beads. Use flat nose pliers to close back solid ring. Repeat the same at the opposite end of the same strand of beads.

2. Attach a solid oval ring to strand of rust fossil beads on same fashion as on step 1. ( both strands will be used just the way it comes from the store- you don't need to restring neither. )

3. Follow instructions below to make all beads dangles and separate them in color groups once you are done.

a.) Feed one 4mm coral bicone bead onto a head pin. Make a simple loop on top of bead, and then trim and set aside. Make 46 more of those and set aside.

b.) On same fashion as in- make 24 dangles using ivory shell beads and 24 dangles using rust fossilbeads. Set them aside separated by color grouping.

4. Cut two 19 inch piece of red stringing wire. Feed ends of both strands on a single EZ crimp end and crimp it using standard crimp tool, then attach the loop of EZ crimp end to a solid oval ring.

5. Carefully open oval solid ring from previous step, attach to strand of rust beads, white shell beads and to another solid oval ring. Close it gently . Start weaving the two strands of red stringing wire between white and rust strand of beads creating and interesting color effect.

6. Create a chain using 38 flower connectors and 39 oval jump rings. Open a round jump ring and attach this chain to one of the strands of rust/red beads. Repeat the same to attach the other end of chain.

7. Using two back to back rounf filigree charms start hanging bead dangles using five cut out spaces on the bottom of charm following below:

•one crystal dark coral, one white shell, one rust bead, one white shell, one crystal dark coral. Make 10 of those and set aside (enough to be used to make the earrings and bracelet.)

8. Open an oval jump ring and attach to the one flower connector, and then open another oval jump ring and attach to bottom loop of connector and to one of the charms made on step 7. Attach one of that on each of the charms made on step 7 ( 10 total.)

9. Open oval jump ring attached ot the end of the necklace and then slide swivel badge onto it. Twist the entire piece to create a waving effect between all the strands and then attach small oval textured linkto the opposite end through oval solid rings.

10. Take 5 of the charms made on steps 7 and 8 and attches to different places around the necklace. Utilize different strands of beads to create a interwined look positioning them as symmetrically as possible.

Optional: Create a small dangle chain with 3 flower connectors and few beads that can be added to oval textured link.

Bracelet:

1. Assemble bracelet on same fashion of the necklace. Use only 3 of hte filigree charms left and measure the size of wires and strands of beads as you desire.

Earrings

1. Please, use photo as your guide. Same jewelry making texhniques use on necklace and bracelet will be used for earrings. The material list incliudes all components needed to make this sassy and girlie pair of earrings.