1. Thread all three strands of wire into two 3mm crimp tubes, through the circle end of the clasp and back into the tubes. Use a pair of chain nose pliers to pull wire through crimps.
2. Leaving approximately a 1/8” gap, crimp the tubes keeping wires separate. Cut off excess wire.
3. Thread two adjacent wires into a glass coin, thread outside wire and the wire next to it into a second coin, then thread each leaf on one of the wires.
4. Holding wires so they are equal lengths; slide a crimp tube over all three and secure wires with crimp tool.
5. Repeat established pattern working until you reach the final leaf.
6. Thread all three wires into two crimp tubes as before and secure on a 5mm jump ring.
7. Attach a second jump ring and the bar end of the clasp to the previous ring and secure.
8. Working around necklace from left side, attach 2 triangles on each segment using jump rings. The triangles should be placed at the top and bottom of the second coin bead.
9. This should be an organic design and the beads and triangles should float freely along the wires.
|
|
