1. Cut a 17 inches piece of beading wire. Feed one end of wire onto one half of EZ clasp. Use EZ crimper pliers to flatten coiled section of EZ clasp.
2. Add a crimp tube to wire and a two 11 inches pieces of beading wire, holding the end of the last one inside of the crimp tube. Crimp all 3 strands together 4 inches away from the crimped end.
3. String on a red bicone onto each of the wires, placing them next to each other but not on top of each other, and then add a crystal rondelle onto all wires and a second section of red beads like the first one.
4. Feed a crimp bead onto both strands together and then keep beading following pattern bellow:
One triangle quartz + sparkle bead + one triangle quartz + one sparkle bead + 5 triangle quartz + stainless steel bead.
Add beads on reverse until the fourth section of red bicones are strung on, then add a #3 crimp tube and crimp it on same fashion you did on opposite side. Adjust the beaded section making sure is laying correctly and then trim excess wire of the 2 last strands added later.
5. Feed the end of single wire onto the other half of EZ clasp, then secure it using mighty crimper tool properly.
6. Cut 6 pieces of wire in 1 ¾“ length. Take a single piece and feed through stainless steel wired ball. Add a crimp tube bead on each side of wire positioning them on each side of ball crimping to secure it in place.
7. Add a red bicone to each side of wire followed by 2 black bead bumpers also on each side. Add a smaller crimp tube and crimp it right at the end of wire. Trim excess wire. Add five more of these in order to finish your necklace. |
|
