Instructions:
1. Release the lock tip of a kidney ear wire, slide one of the crystal pendant to the curved portion of upside down ear wire. Close ear wire and then using tip of round nose pliers make a small loop flush with wire. Use round nose pliers to close the other locking place of ear wire. Repeat same step with two other crystal pendants. Set them aside.

2. Open a copper jump ring, slide a square and a diamond gold-plated links. Close jump ring. Open another jump ring and scoop up diamond link and set aside. Make 7 more of those sections and set them aside.  

3. Using only 25 links of silver plated quick link chain attach one end link to outside ring of slide claps. Repeat the same to attach other end of chain.

4.  Find the center of previously attached chain and add a dangle made with kidney ear wire and olivine crystal rock pendant from step 1. Skip two links to the right and then add another crystal pendant. Skip two links to the left and attach last crystal pendant.

5. Working from middle of the necklace to right attaché one gold-plated quick link dangle made on step 2 to empty link next to center crystal pendant.  Add a second dangle to next empty link. Repeat same step to add two more dangles next to other crystal pendant.
Repeat the same to finish this section of necklace.
(use picture as guidance).

6.  Attach 18 links of silver-plated large diamond w quick links to inside rings of sliding clasp.

7. Place strategically 2 copper jump rings on each side of necklace holding both chains together.

Earrings
1. Slide a clear square bead onto ball star head pin. Make a wrapped loop on top of bead.

2. Attach two copper jump rings on each edge of a single silver-plated diamond quick link and then attach those to crystal dangle and to lever back.

3. Repeat all to make matching earrings.