Aqua & Black
1. Pass an Eye Pin through an aqua disc bead and make a large loop to attach it to a Badge Clip.
2. Connect an Eye Pin to the loop below the aqua disc bead and pass it through a black glass bead. Make another loop.
3. Pass a Head Pin through a turquoise bead and make a loop to connect it to the loop below the black glass bead.
4. Use a Crimping Tool to close a sparkle Crimp Cover.
5. Pass a Head Pin through the closed Crimp Cover and make a wrapped loop to attach it to the loop above the aqua disc bead.
Black & Gray
1. Pass an Eye Pin through the 20mm gray bead and make a large loop to attach it to the Badge Clip.
2. Pass a Head Pin through a black bead and make a wrapped loop; repeat twice more.
3. Use a Jump Ring to connect the beaded Head Pins to the upper loop on the Eye Pin.
4. Cut two 5" lengths of Beadalon 7.
5. Center the wires through lower loop on the Eye Pin and pass the ends through a Crimp Bead.
6. Slide the Crimp Bead up the wires to define a small loop.
7. Cover the Crimp Bead with a Crimp Cover.
8. Pass each wire end through a chip and Crimp Bead. Crimp it. Attach a Crimp Cover.
9. Repeat Step 8 for each wire end.
Gray & Silver
1. Connect an Eye Pin to the Badge Clip.
2. Pass it through a hole on the bead frame, through 3 chips and the other hole and make a basic loop.
3. Connect another Eye Pin to the loop below the bead frame. Pass it through a gray oval bead and make another loop.
4. Connect another Eye Pin to the loop below the oval bead. Pass it through a Bead Cap, coin bead, and Bead Cap. Make another loop.
5. Cut five lengths of Cable Chain: 1 ¼", 1 ½", 1 ¾".
6. Attach one end of each piece of chain to the loop below the coin bead.
|
|
