• 30 black diamond 6mm Crystallized™ - Swarovski Elements rounds #5000
• 11 black diamond 8mm Crystallized™ - Swarovski Elements rounds #5000
• 6 dark gray pearl 4mm Crystallized™ - Swarovski Elements rounds #5810
• 5 dark gray pearl 6mm Crystallized™ - Swarovski Elements rounds #5810
• 40" length of .21" Kink Free Ti #JW05TI-10FT
• Gunmetal heavy round link chain #340C-160
• Gunmetal jump rings, spring ring from variety pack #356C-010
• Gunmetal #2 crimp tubes from variety pack #305X-129
• White head pins #312E-013
• Round nose pliers #201A-104
• Chain nose pliers #201A-101
• Wire cutters #202A-105
• Crimping tool #JTCRIMP1 |
|
|
|
1. Separate a 16" length of chain (or desired length of necklace) and use a 6mm jump ring to attach the clasp to one end.
2. Separate five sections of chain that are each 13 links long. Use a 6mm jump ring to attach a 13-link chain to the center of the necklace; the eighth link away on each side of the center chain; and the sixteenth link away on each side of the center chain.
3. Pass a head pin through a 6mm pearl, two 6mm jump rings and a 8mm crystal. Make a basic loop. Repeat for five total head pins. Connect a beaded pin to the last link on each 13-link chain.
4. Pass a head pin through a 8mm crystal, two 4mm jump rings and a 4mm pearl. Make a basic loop. Repeat for six total head pins. Use a 6mm jump ring to attach one beaded pin to the fourth link away from the center on each side; eighth link away from the center on each side and twentieth link away from the center on each side of the necklace.
5. Cut six 4 ½" lengths of Kink Free Ti. String three 6mm crystals and a crimp tube onto one wire, then pass the wire through the crimp tube again to form a circle; crimp it. Repeat for each length of wire.
6. Cut four 3 ½" lengths of Kink Free Ti. String three 6mm crystals and a crimp tube onto one wire, then pass the wire through the crimp tube again to form a circle; crimp it. Repeat for each length of wire.
7. Connect one circle from Step 5 to the jump ring connecting the 13-link chain to the center of the necklace. Use a 6mm jump ring to connect another circle to the third link down on the same chain. Connect a large circle to the jump ring at the top of each remaining 13-link chain.
8. Connect one circle from Step 4 to the jump ring connecting the first and second beaded head pins from Step 4 on each side of the necklace. |
|
|
|
