1. Cut crinkle wire in 2 pieces of 18” each.
2. String one crystal disc (light topaz) + 2 jump rings + one crystal disc (light topaz) and find the center of wire. String two # 2 crimp tubes on each side of crystal and crimp it. This is the center of the necklace. Leave some space between the discs so the jump rings are a lit of bit loosen.
3. String 1 crimp + jet disc + 2 crimps + lt topaz disc + 2 crimps + jet disc + 2 crimps + lt topaz disc + 2 crimps + jet disc + 1 crimp.
Repeat this pattern asymmetrically to the other side of necklace.
4. String both end of necklace into the EZ crimp and crimp it using Mighty crimp tool. Hold tool firm on your hands and crimp both strands of crinkle wire, make sure it’s secured properly and trim excess using flush cutters.
5. Cut a 10” piece of crinkle wire. String the following beads into the crinkle wire: 2 crimps + 1 lt topaz + 2 crimps. Repeat this pattern until you have used 8 discs. Remember to add two #1 crimps every time you add a disc.
6. Leave ½ inch space between beads and make a circle and attach both ends using 1 crimp tube #1.
7. Make two more circles like the one from step 6. They both need to be smaller than the first one, so they can be inside of each other.
8. After you have all 3 circles done, attach them to the jump rings on the center of necklace. Use 2 jump rings for each connection so the “pendant” hung correctly.
|
|
