Finished Size=
26” with dangles
Note: Use the Spin-n-Bead to string seed bead sections. When threading back through beads to create the beaded dangles, use a straight flexible beading needle. You’ll have lots of leftover beads but it’s easiest to string beads quickly when the the Spin-N-Bead is full.
- Cut the thread into three equal lengths and attach a stopper bead 3” from the end of each thread.
- First strand: string 6” of seed beads. Pass the needle through a CZ-Gem Dropz and back through 2 ½” of seed beads. String 4” of seed beads. Pass the needle through a CZ-Gem Dropz and back through 2 1/2” of seed beads; repeat five more times. String 3 ½” of seed beads and a stopper bead.
- Second strand: string 7” of seed beads. Pass the needle through a CZ-Gem Dropz and back through 1 ½” of seed beads. String 3” of seed beads. Pass the needle through a CZ-Gem Dropz and back through 1 ½” of seed beads, repeat three more times. String 5 ½” of seed beads.
- Third strand: string 7” of seed beads. Pass the needle through a CZ-Gem Dropz and back through 4” of seed beads; repeat four more times. String 3” of seed beads.
- Cut the ColourCraft wire length in half.
- Make a wrapped loop on one end of the wire.
- Remove the stopper beads from one end of each beaded thread and tie them to the wrapped wire loop. Place a drop of jeweler’s cement on the knot and cut off any extra threads.
- Place the wire end through the wide end of the beading cone and make another wrapped loop on the other side of the cone to attach half of the clasp.
- Repeat Steps 6-8 for the other end of the necklace.
