• Eclectic Filigree Earrings • |
|
• 2 - Filigree rectangle 3-to-1 ring end connectors (326B-141)
• 6 in. (15.24cm) length - Small cable chain, silver plating (340B-001)
• 8 - 6mm Medium jump rings, silver plating (314B-005)
• 6 - 8mm Large jump rings, silver plating (314B-008)
• 6 - 5.3mm 1-hole flat disc spacer beads, silver plating (522B-010)
• 4 - 9.4mm 1-hole flat disc spacer beads, silver plating (522B-012)
• 2 - 9.4mm 2-hole flat disc spacer beads, silver plating (522B-014)
• 2 - 12mm 1-hole donut flat disc spacer beads, silver plating
(522B-017)
• 2 - Ball & spring French ear wires, silver plating (308B-001)
• Designer chain nose pliers (201E-002)
• Nipper tool (JTNIP1) |
|
|
|
| Tip: Open jump rings by turning one arm of the ring to the side rather than pulling the ends directly apart. |
1. Attach an ear wire to the top loop on the filigree component.
2. Cut three 1 in. (2.54cm) lengths of silver small cable chain.
3. Using a 6mm jump ring, attach a piece of chain and a 5.3mm 1-hole flat disc spacer bead to each outer loop on the filigree component.
4. Using a 8mm jump ring, attach a 9.4mm 1-hole flat disc spacer bead to the last link on each piece of chain attached to an outer loop on the filigree component.
5. Using a 6mm jump ring, attach a 9.4mm 2-hole flat disc spacer bead to the center loop on the filigree component.
6. Using a 6mm jump ring, attach a piece of chain and a 5.3mm 1-hole flat disc spacer bead to the lower hole on the 9.4mm 2-hole disc.
7. Use a 10mm jump ring to attach a 1-hole donut to the last link on the center chain.
8. Repeat steps 1 – 7 to complete the other earring. |
|
|
|
