• Fringe Element Bracelet • |
|
• 1 1/2 yard length (137cm) - Elonga™ stretchy bead stringing cord, 0.30mm (131U-001)
• 12 in. (30.5cm) length - Elonga stretchy bead stringing cord, .70mm (133U-001)
• 1 - 1oz. package Amethyst seed/bugle bead mix*
• 1 - 1oz. package Amethyst 4-10mm bead mix*
• 1 - Size 10 Hard beading needle (JNEEH10/6)
• G-S Hypo™ Cement (JA-GSHYPO)
• Designer beading scissors (211A-002)
• Designer beading awl (206A-010)
• Bead mat (218H-010)
• Clipboard* |
|
|
|
1. Hold the 0.30mm and 0.70mm Elonga thread ends together. Leave 1 in. and tie them in a figure-8 knot. Place a drop of glue on the knot. Attach the 1 in. tails to a clipboard to hold the threads while you work.
2. To make fringe, thread a needle onto the 0.30mm Elonga. String 1/4-1/2 in. of seed/bugle beads, an E bead or 4mm bead and another seed bead. String the needle back through the E or 4mm bead and the seed/bugle beads. Poke the needle tip into a beading mat and use your fingers to work the beads down. Use a beading awl to adjust the placement of the fringe.
3. Make two fringes, then string a seed bead onto both threads. Make two more fringes, then string an 8-10mm bead onto both threads. Repeat this beading pattern until the bracelet reaches the desired length.
4. After stringing the last 8-10mm bead, remove the Elonga ends from the clipboard. Tie the ends together using a surgeon's knot. Place a drop of glue on the knot. When the glue is dry, cut off any excess thread. |
|
|
|
