Necklace
1. Cut piece of Beadalon® approx. 18”. On one end of the wire, thread on one crimp bead about ½” down. Hold in place with your fingers and place same end through loop of clasp and feed back through the crimp bead. Push crimp bead up to meet clasp, pull tightly and crimp closed.
2. Begin threading beads as follows: (The first few beads will go over small piece of Beadalon®.)
3. 2-D, A, D, B, C, D, A, E, B, E, A, D, C, B, C, D, E, A, E, D, C, B, D, A, D, C, E, B, E, C, E, A, E, A, D, C, B, D, E, A, E, C, B, E, D, A, D, E, C, B, D, A, E, D, C, E, B, E, C, D, A, D, B, D, E, A, D, C, B, C, D, E, A, E, A, D, C, B, D, A, D, B, C, 2-D.
4. At the end, slip on crimp bead and feed end of Beadalon through end of clasp and then back through crimp bead and first 4 beads. Pull tightly so everything is secure and crimp the bead closed. Trim excess Beadalon®.
Bracelet
1. Same as Necklace instructions step #1.
2. Begin threading beads as follows:
3. 2-D, A, E, B, E, D, C, B, D, E, A, E, D, C, B, D, A, D, E, B, E, A, 2-E, A, D, C, B, D, E, A, E, D, B, E, C, A, D.
4. Same step as necklace #4. |
|
