1. Cut a 28” length of Silver Plated wire.
2. Attach wire to EZ Crimp end by sliding wire inside crimp end and securing with crimp tool.
3. Measure down .5” and slide a jet bead on wire. Slide wire over and back through jet bead forming a tight loop to secure bead on wire, tighten loop so it is flush to the jet bead, slide on a crystal copper bead, slide a second jet bead against the crystal copper and loop wire through it as before, pulling tight. The beads should be flush to one another.
4. Measure down approx. .5” and repeat process, replacing the crystal copper bead in the center with a silk rondelle.
5. Repeat this pattern until you reach the final segment. Slide wire into EZ Crimp clasp crimp tube and secure with crimp tool as before.
6. Use flush cutters to remove any exposed wire from inside of EZ Crimp tube end.
7. Work your way back through the design to ensure all segments are flush together.
|
|
