1. Attach 6000 Sapphire 13x18mm crystal pendants with triangle jump rings (314A-231) by carefully opening the jump ring and guiding the two ends of the jump ring into the hole in the pendants. Make sure to close the jump ring fully, make sure not to chip the pendant when closing. Set aside.
2. String onto a gold plated eye pin (310A-113) one 4mm sparkle bead, one Swarovski 5000 Montana blue 5mm crystal and one 4mm sparkle bead, make a loop out of the unfinished end. Make six of these and set aside.
3. Cut Polyester chain in two pieces approximately 3 long, attach end of one to the ring on the designer spring ring with an oval jump ring, make sure to open the jump ring to the side. Attach the end of the other piece to the figure eight portion of the clasp with another oval jump ring. Carefully close the jump rings.
4. Attach one end of the polyester chain to the other oval jump ring and onto the triangle shape ear wire, use the Beadfix glue with precision applicator to glue the ear wire into the receptacle (this will secure this portion for use on the necklace).
5. Attach the triangle ear wire to one of the 16mm twist solid rings with 2 of the 4mm round jump rings. Use one of the eye pins (made in step 2) and attach to the 16mm twist solid ring, then to another 16mm twist solid ring, continue this process until there are 3 eye pins connecting to 4 16mm twist solid rings.
6. Repeat steps 4 & 5 to complete the opposite side. Then attach 6 of the items made in step 1 to 6 of the 16mm twist solid rings with 4mm jump rings. Leave the two solid rings closest to the clasp without a pendant attached.
7. String a wire guardian onto Beadalon wire then over the last 16mm solid ring, close the wire guardian so the ends touch, then string on a crimp bead and crimp. Open a sparkle bead with the bead opening tool then carefully cover the crimp bead and close.
8. String on sparkle beads and 5000 Swarovski beads in the pattern shown, leave enough room for the 3 headpins (at the double sparkle beads). Use a crimp bead at the bottom of the pattern.
9. Use the bead opening tool to open another sparkle beads and cover the crimp bead.
10. Repeat steps 7-9 to complete the other side.
11. Use an eye pin and string on the pattern shown, make a loop at the opposite end, then attach to the left side of the necklace at the double sparkle beads, then to the right side. Hang 3 of the items made in step 1 in-between the double sparkle beads with a round jump ring.
12. Using an eye pin string the next shorter eye pin with the shorter pattern and attach using the same instructions from step 11. Connect 2 of the items made in step 1 with round jump rings between the double sparkle beads.
13. Finally, string the last eye pin with the pattern, and connect the last item from step 1 with the final jump ring. |
|
